BMW Coolant Flush Procedure
Learn how a BMW coolant flush works, from draining the cooling system and refilling the right coolant to bleeding air out and recording the service.
Contents
- Draining and refilling the system
- Bleeding air out of the cooling system
- Recording the flush in your service log
- BMW Coolant Flush Questions
- What coolant type does a BMW cooling system need?
- How do I bleed air from the BMW cooling system?
- What is the coolant capacity for BMW models?
- What does a BMW expansion tank do during a flush?
A BMW coolant flush procedure replaces old coolant in the BMW cooling system with fresh coolant of the specified type. The job means draining the system, flushing or refilling it, and bleeding air from the BMW cooling system so the engine cools evenly. The exact coolant capacity for BMW models depends on the engine and model, so check the specification for your car. Record the date and coolant type used in your service notes so the next flush is easy to plan.
Draining and refilling the system
Old coolant leaves the BMW cooling system through the drain point at the radiator or the engine block. Open the expansion tank cap only when the engine is cold, because hot coolant can scald. Refill with the BMW coolant type your model specifies, which is often a phosphate-free formula mixed to the ratio the label gives. The coolant capacity for BMW models depends on the engine, so pour in the amount your manual lists rather than guessing.
Bleeding air out of the cooling system
Trapped air is the main reason a BMW cooling system overheats after a flush. The bleed procedure uses the bleed screw near the expansion tank or the electric pump test cycle on models that have one. Run the engine with the heater on and watch the coolant level at the BMW expansion tank until it holds steady. A specialist should handle pressurized bleeding on models that need diagnostic equipment.
Recording the flush in your service log
A coolant flush belongs in your service record along with the date and the coolant type used. Note the mileage and the amount that went in, so the next owner or mechanic can compare it with the listed capacity. Keep the purchase or service receipt with the entry to show what was done. A written record makes the next coolant service easier to schedule and verify.
BMW Coolant Flush Questions
What coolant type does a BMW cooling system need?
BMW coolant type depends on the model and engine, so use the spec listed in your owner's manual or on the coolant label. Many BMW engines use a phosphate-free coolant mixed with distilled water to the ratio on the bottle. Never mix coolant types without checking that they are compatible. Using the wrong coolant can damage seals and the radiator in the BMW cooling system.
How do I bleed air from the BMW cooling system?
Bleeding air from the BMW cooling system removes the pockets that stop coolant from reaching the heater core and cylinder head. Open the bleed screw at the expansion tank while filling and run the engine with the heater set to hot. Many BMW models also run an electric water pump cycle that bleeds the system automatically. Follow your model's steps, and let a trained specialist handle the job if the system needs pressurized bleeding.
What is the coolant capacity for BMW models?
Coolant capacity for BMW models varies with the engine, the radiator size and whether the car has a separate circuit for the turbocharger or battery. Check the owner's manual or a workshop data source for the figure for your model. Fill to the mark on the BMW expansion tank rather than to a guessed number. The amount drained during a flush also depends on how much old coolant stays in the block and heater core.
What does a BMW expansion tank do during a flush?
The BMW expansion tank holds coolant as it heats and gives you a place to check and top up the level. During a flush, watch the level in the tank and add coolant as air works out of the system. The cap on the expansion tank keeps the system pressurized, so it must be closed properly afterward. A cracked tank or a weak cap causes coolant loss that looks like a fault after the flush.