Car Jack and Jack Stands Combo Sets
What a car jack and jack stands combo set includes, how load ratings work, and how to lift a vehicle safely before you record the service.
Contents
- What a combo kit contains
- Reading load ratings correctly
- Lifting safely before you record work
- Questions about jack and stand sets
- Are car jack and jack stands combo sets enough for a full brake job?
- What is the difference between a floor jack and axle stands in a set?
- How do I choose the load rating for a jack and stand set?
- Can I use a car jack and jack stands on a gravel driveway?
A car jack and jack stands combo set pairs a hydraulic floor jack with two or more rigid stands, so the jack lifts the vehicle and the stands hold it while you work underneath. The set covers two jobs that must stay separate: lifting and supporting. The jack is a tool for raising a corner of the vehicle, while the stands carry the weight once the car is in the air. Buying them together keeps the load ratings matched and saves you from pairing a jack with stands that do not fit its lift range.
What a combo kit contains
A combo kit bundles a floor jack with a pair of jack stands, and some sets add wheel chocks or a creeper. The floor jack rolls on casters and uses a hydraulic ram to raise a lifting saddle under a jacking point. Jack stands, also called axle stands, are fixed-height or pin-adjusted supports with a ratchet bar and a wide base. Matching the two parts in one kit matters because the jack must lift the vehicle high enough to clear the stand's lowest setting.
Reading load ratings correctly
The load rating of each part is the weight it is built to hold, and the jack and the stands carry different loads. A floor jack raises one corner or one axle at a time, so its rating must exceed the weight on that point, not the whole vehicle. Jack stands hold a raised corner for as long as the car stays up, so their rating must cover the load they support with margin. Compare both numbers against the vehicle weight rating in your owner's manual before you buy.
Lifting safely before you record work
Lifting safety starts with a level, hard surface where the jack casters can roll and the stands sit flat. Set the parking brake, chock the wheels that stay on the ground, and place the jack only at the lifting points the manufacturer marks. Raise the vehicle, slide the stands under the axle or frame at the same height, and lower the jack so the stands take the load. Never work under a car held only by the jack, and have a trained specialist handle any job beyond your tools.
Questions about jack and stand sets
Are car jack and jack stands combo sets enough for a full brake job?
A car jack and jack stands combo set is enough to raise and support the vehicle for a brake job at home. The set holds the car while you remove wheels and work at each corner. You still need the hand tools, torque wrench and brake parts for the job. Work on a level surface and place the stands at the frame points the manual lists.
What is the difference between a floor jack and axle stands in a set?
A floor jack in a combo set is the lifting tool, and the axle stands are the supports that hold the car up. The jack raises the vehicle with hydraulic pressure, then you place the stands and release the jack. Axle stands have no lifting action of their own. Treat the two roles as separate, and never rely on the jack alone.
How do I choose the load rating for a jack and stand set?
Choose a load rating that exceeds the weight the jack or stand actually supports, not the total vehicle weight. Check the vehicle weight rating in the owner's manual and the load on the corner or axle you plan to lift. A floor jack rated well above that corner load leaves room for the vehicle's shifting weight. Stands should match or exceed the load they hold while the car is raised.
Can I use a car jack and jack stands on a gravel driveway?
No, a car jack and jack stands should not be used on gravel, grass or soft ground. Loose or uneven surfaces let the jack casters sink or roll and the stand base tilt under load. Move the car to a level, hard surface such as concrete before lifting. Chock the wheels and check that each stand sits flat before you go under the vehicle.