# EV Charger Installation Problems and Faults

What causes EV charger installation problems, from supply capacity and consumer unit upgrades to connection faults, plus what to record for the installer.

EV charger installation problems and faults come from the electrical supply, the wiring route, the consumer unit, or the charger setup itself. An installer assesses the property before fitting a home charge point, and the findings decide whether the job runs straight or needs extra work. Recording each fault, the date and what the installer changed gives you a service history you can act on later. The points below explain the usual snagging items and the questions to ask when a charger will not connect. 

## Supply capacity and load checks 

Supply capacity issues appear when the incoming electrical supply cannot carry the charger alongside the rest of the home load. An installer measures the existing demand and may fit a device that pauses charging when household use is high. A consumer unit upgrade is sometimes needed to create a protected way for the charger circuit. The service record should note the supply reading taken on the day and any device fitted to manage load. 

## Wiring route and earthing faults 

Installation faults often trace back to the cable route, the protective earth arrangement, or a loose termination at either end. A long run to a detached garage can raise voltage drop, so the cable size matters as much as the charger model. Earthing arrangements differ between properties and an installer must verify the one in place before energizing the circuit. Snagging visits are the point to log any retermination or cable change against the date. 

## When the charger will not connect 

A charger not connecting may have lost its network link rather than its power, so check the charger display before calling anyone. Connection faults can sit in the charger settings, the home network, or the account linked to the device. Installer snagging should confirm the charger firmware state and the isolation switch position at the same visit. Keep the fault code and the time it appeared, because that detail shortens the next diagnosis. 

## Questions About EV Charger Installation Faults 

### Why does my EV charger fail to connect after installation? 

An EV charger that fails to connect after installation often has a network or account fault rather than a wiring fault. Check the charger indicator and note any fault code before contacting the installer. The installer can then confirm whether the issue sits in the charger settings or the supply. 

### What are typical EV charger installation issues? 

Typical EV charger installation issues include supply capacity limits, a consumer unit that needs upgrading, long cable runs and earthing checks. An installer surveys the property first and records what the supply can carry. Each finding belongs in your service record with the date of the visit. 

### Does a home charger need a consumer unit upgrade? 

A consumer unit upgrade may be needed when the existing board has no spare protected way for the charger circuit. The decision rests on the board type, the spare capacity and the result of the load check. An installer must confirm this, since the work involves the main electrical distribution. 

### What should I note when the installer returns for snagging? 

Installer snagging notes should record the fault as you described it, the date, and the part or setting the installer changed. Note any fault code shown on the charger and whether the supply device was adjusted. These details build a service history that supports any later warranty claim.
