Ford F-150 Cabin Air Filter Replacement (2010 Model)
How the 2010 Ford F-150 cabin air filter is reached, how the housing cover comes off, and what to keep in a service record when you change it.
Contents
- Where the filter sits on a 2010 F-150
- Remove the glovebox and housing cover
- Fit the new filter and log the work
- Questions about F-150 cabin filter service
- How do I replace the cabin air filter on a 2010 F-150?
- Do all 2010 F-150 trucks have a cabin air filter?
- What does a dirty cabin air filter do to the vents?
- Which details should go in the service record for this job?
Ford F-150 cabin air filter replacement on the 2010 model is a job done from inside the truck, at the filter housing reached through the glovebox area. The filter cleans the air pulled into the heating, ventilation and air conditioning system, which is often called HVAC, and a clogged filter shows up as weak airflow or odors from the vents. This page explains where the filter sits, how to open the housing and swap it, and which details belong in your service record.
Where the filter sits on a 2010 F-150
The 2010 F-150 cabin air filter location is behind the glovebox, in a housing built into the duct that feeds the HVAC case. The filter is reached by dropping the glovebox out of its opening rather than from the engine bay. Some 2010 trucks were built with a filter housing that holds a filter, and others were built without one, so look at the housing before buying parts. Confirm the layout on your own truck before you start the job.
Remove the glovebox and housing cover
Glovebox cabin filter access on the F-150 starts with emptying the box and pressing in its sides so it swings down past the stops. Behind it, a rectangular plastic filter housing cover sits over the filter slot and is held by tabs or small fasteners. Filter housing cover removal takes light pressure, because the plastic clips snap if they are forced. Keep the fasteners in a tray so they go back in the same places.
Fit the new filter and log the work
The filter slides into the slot with the airflow arrow on its edge pointing in the direction the housing marks as the flow path. A cabin air filter part number belongs to the truck's model year and build, so match the number to the old filter or the housing label. Press the cover back until the tabs click, then refit the glovebox and test the blower at each speed. Write the date, the filter number and the odometer reading in your service record while the details are fresh.
Questions about F-150 cabin filter service
How do I replace the cabin air filter on a 2010 F-150?
Replacing the cabin air filter on a 2010 F-150 means opening the glovebox, letting it swing down, and opening the filter housing behind it. You then pull the old filter out, slide the new one in with its airflow arrow facing the correct way, and close the cover. The glovebox goes back last, and the blower should be checked at every speed.
Do all 2010 F-150 trucks have a cabin air filter?
No, not every 2010 F-150 was built with a cabin air filter in place. Some trucks have a housing that accepts a filter and others left the factory without one, so check the housing behind the glovebox first. If no filter slot is there, the truck cannot take a drop-in filter without added parts.
What does a dirty cabin air filter do to the vents?
A loaded cabin air filter restricts the air moving into the HVAC case, and that shows as weaker airflow from the vents. Odors from the HVAC can also come from debris trapped in the filter and housing. A filter that looks gray and packed with leaves or dust is ready to be swapped.
Which details should go in the service record for this job?
The service record for a cabin air filter change should list the date, the odometer reading and the part number of the filter used. The 2010 model year and the build details of the truck belong there too, because the correct filter depends on them. Adding the next inspection note helps you track airflow and odor between changes.