# FRAM and Donaldson Air Filter Dimension Charts

Learn how to read FRAM and Donaldson air filter dimension charts, which measurements matter, and how to cross-reference part numbers by size safely.

FRAM and Donaldson air filter dimension charts list the measured size of each filter by part number. Each entry gives the filter shape, its key measurements and the seal type. You will also see how to read each chart and when matching size alone falls short. 

## How to read a FRAM size chart 

A FRAM air filter dimensions chart lists each FRAM part number with its shape and measurements. Panel filters show length, width and height, while round filters show outside diameter, inside diameter and height. The catalog shows measurements in inches, and many listings add millimeters as well. Check the catalog notes too, because gasket style or tab position can differ between similar sizes. 

## Donaldson dimensions for heavy-duty elements 

Donaldson air filter dimensions are listed by Donaldson part number in the heavy-duty catalog and online lookup. Many Donaldson filters are cylindrical elements built for trucks, tractors and off-road equipment. For these, the chart gives outside diameter, inside diameter at each end and overall length. The chart also names the seal design, such as a radial seal that grips the housing outlet tube. 

## Cross-referencing filters by size and seal 

A size cross-reference between FRAM and Donaldson filters starts with matching every listed dimension. Matching outside diameter alone can leave a gap at the seal that lets dirt past the element. Seal type, end cap design and filtration rating also have to agree with the original part. Writing both part numbers in the vehicle service record makes the next filter change quicker to plan. 

## Questions about air filter dimension charts 

### Where do I look up the size of a FRAM air filter? 

FRAM filter sizes are listed in the FRAM online catalog and in printed application guides. You can search by FRAM part number or by vehicle make, model and engine. The product page then shows the measurements and an image of the filter. 

### Can I measure my old air filter instead of using a chart? 

Yes, you can measure the old air filter with a tape or caliper to confirm its size. For a round filter, measure outer diameter, inner diameter and height across the rubber seal. Compare those figures with the chart, since a crushed or swollen gasket can skew the reading. 

### Does a Donaldson filter fit if the dimensions match the FRAM one? 

Not always, because a Donaldson filter with matching dimensions may still use a different seal or end cap. The housing on many heavy-duty engines needs a specific seal design to block unfiltered air. Check the Donaldson cross-reference listing, which links competitor part numbers to the matching element. 

### Why do two filters with the same size have different part numbers? 

Two air filters of the same size can differ in filter media, seal material and flow rating. One version may add a pre-cleaner layer, a safety element or flame-retardant media. Those differences change performance, so the part number matters as much as the dimensions.
