# How to Replace Wiper Blades on a Lexus RX 350

Steps to remove and fit wiper blades on a Lexus RX 350, including the arm lock tab, blade fitting type, and matching the correct blade size.

Replacing wiper blades on a Lexus RX 350 is a job you can do yourself once you match the blade size and fitting type to the vehicle. The wiper arm holds the blade with a lock tab that you press to release it, and the new blade clicks into the same hook or connector. Working slowly with the arm folded away from the glass protects the windshield and the arm spring, and logging the date and blade size in your service record makes the next change simpler. 

## Match the blade size and fitting 

The Lexus RX 350 wiper blade size differs between the driver side, the passenger side, and the rear window where fitted. Blade length is printed on the old blade or listed in the owner's manual, and the fitting type is the shape of the connector on the arm. Buy blades that state the correct length and connector, because a blade that is too long can strike the pillar or the cowl. Keep the packaging note with the date so your service record shows what went on the vehicle. 

## Release the wiper arm lock tab 

A wiper arm lock tab is the small plastic clip on the connector that holds the blade onto the arm. Lift the arm off the glass and press the tab while sliding the blade down and away from the hook. If the tab is stiff, steady pressure with a small flat tool frees it without forcing the arm. Hold the arm with one hand the whole time, since a released arm can snap back onto bare glass. 

## Fit the new blade and check it 

Slide the new blade onto the arm until the lock tab clicks into place, then tug it gently to confirm it is seated. Lower the arm onto the glass and run the wipers at low speed while you watch for chatter, missed patches, or a blade that lifts at the ends. A blade that skips may sit on the wrong connector or on a dirty windshield, so clean the glass and refit it. Record the date and the blade size in your maintenance notes to keep the service history complete. 

## Lexus RX 350 wiper questions 

### How do I replace wiper blades on a Lexus RX 350? 

You replace wiper blades on a Lexus RX 350 by lifting the arm, pressing the lock tab on the connector, and sliding the old blade off the hook. Push the new blade on until the tab clicks, then lower the arm and test the sweep on a wet windshield. Doing one arm at a time keeps the parts straight and protects the glass. 

### What wiper blade size does a Lexus RX 350 take? 

A Lexus RX 350 takes different blade lengths on the driver side, the passenger side, and the rear window where one is fitted. The correct size is printed on the old blade or listed in the owner's manual for your model year. Measure the old blade if the label is worn, and note the size in your service record. 

### What is the wiper arm lock tab and how does it work? 

The wiper arm lock tab is a small clip on the blade connector that locks the blade onto the arm hook. Pressing the tab inward releases the clip so the blade can slide off. A new blade clicks into the same tab, and a gentle tug confirms the clip has caught. 

### Which blade fitting type fits the Lexus RX 350 arm? 

The blade fitting type on a Lexus RX 350 is set by the connector shape on the arm, which follows the model year. Check the connector on the old blade and match it to the new blade's stated fitting. Buying by fitting type rather than length alone avoids a blade that will not lock on.
