Measuring Car Tire Size
Learn how to measure car tire size by reading sidewall markings for width, aspect ratio, rim diameter and overall diameter, and record it for service notes.
Contents
Measuring car tire size starts with the sidewall markings molded into the rubber, which give the width, aspect ratio and rim diameter in one code. A tape measure confirms figures the code does not show, such as the overall diameter of the mounted tire. Writing the result into your service record keeps a dated note of what the vehicle actually runs.
Reading the sidewall size code
Sidewall markings carry the size as a sequence such as 225/45R17, and each part has a meaning. The first number is the tire width in millimeters, measured across the inflated tire from sidewall to sidewall. The number after the slash is the aspect ratio, the sidewall height expressed as a percentage of the width. The R stands for radial construction and the final number is the rim diameter in inches.
Confirming width and rim diameter
A tape measure gives a working check on the two figures a wheel or tire change depends on. Tire width millimeters can be read with the tire mounted and inflated, measuring across the widest point of the tread and sidewalls. Rim diameter is measured bead seat to bead seat inside the wheel, not across the outer lip. A trained tire specialist should handle any measurement taken with the vehicle raised.
Calculating overall diameter for records
Overall diameter combines rim diameter, sidewall height and a small allowance for wear and load. Multiply the width by the aspect ratio to get one sidewall height, double it, then add the rim diameter converted to the same unit. The figure from the markings is nominal, while a physical check of the mounted tire shows the real size. Note which value you recorded so later entries stay consistent.
Questions About Car Tire Size
How do I read the size on a car tire?
Car tire size is read left to right from the sidewall code in the form 225/45R17. The 225 is the width in millimeters, the 45 is the aspect ratio as a percentage of that width, and the 17 is the rim diameter in inches. The letter between the last two numbers shows the construction type, with R for radial.
Where do I measure tire width in millimeters?
Tire width in millimeters is measured across the widest part of the inflated tire, including the sidewall bulge. The sidewall marking already states this nominal figure, so a tape measure mainly confirms that the fitted tire matches it. Measure on a level surface with the tire at its normal pressure.
What is aspect ratio on a tire?
Aspect ratio is the sidewall height written as a percentage of the tire width. A 225/45 tire has a sidewall about 45 percent of its 225 millimeter width, which works out near 101 millimeters. A lower ratio gives a shorter sidewall, while a higher ratio gives a taller one on the same width.
Can I work out overall diameter from the sidewall?
Overall diameter can be estimated from the sidewall code by doubling the sidewall height and adding the rim diameter in matching units. The result is a nominal figure based on the markings, not a physical measurement. A direct check with a straight edge across the mounted tire gives the size as it sits on the vehicle.