# Motorcycle Tire Size Speedometer Error Calculator

How a change in motorcycle tire diameter shifts speedometer and odometer readings, and how to work out the error from your front and rear tire sizes.

A motorcycle [tire size speedometer error calculator](/articles/tire-size-speedometer-and-odometer-error-calculator/) compares the rolling diameter of your original tire with the diameter of the tire you fit, then converts that difference into a percentage of speed and distance error. Because the speedometer is driven by wheel rotation, a taller or shorter tire turns fewer or more times over the same ground, and the gauge drifts away from true road speed. The page explains the diameter change, the arithmetic behind the correction, and what the reading means for your odometer record. 

## Why tire diameter changes the reading 

Speedometer calibration on a motorcycle assumes one tire diameter, set when the gauge is matched to the bike. A taller tire covers more ground per revolution, so the speedometer reads lower than actual road speed at any given engine speed. A shorter tire covers less ground per turn and pushes the reading higher. The error grows in proportion to the change, so a small diameter difference stays small and a large one is easy to notice. 

## Reading front and rear tire size 

The front and rear tire size on a bike are stated separately, and only the wheel that drives the speedometer sensor affects the gauge. A front-wheel sensor follows the front tire, while a sensor on the gearbox or rear wheel follows the rear tire and the final drive ratio. Work out the diameter from the sidewall numbers on that wheel before you compare anything. Mixing the two wheels gives a correction that does not match the gauge. 

## Turning diameter change into an error 

A calculator converts each tire size into a rolling diameter, divides the new diameter by the old one, and expresses the result as a percentage. Multiplying a displayed speed by that factor gives the road speed the bike is actually doing. Odometer accuracy on bikes follows the same factor, so recorded distance shifts by the same percentage as speed. Keep the original tire size on file so the correction can be recalculated after any later change. 

## Motorcycle speedometer and odometer questions 

### How does a tire size speedometer calculator work for a motorcycle? 

A tire size speedometer calculator compares the rolling diameter of the stock tire with the fitted tire and returns a percentage difference. That percentage is applied to the displayed speed to estimate true road speed. It also applies to distance, so the odometer error matches the speed error. The result depends on the exact tire sizes and on which wheel drives the sensor. 

### Does a taller tire make the speedometer read high or low? 

A taller motorcycle tire makes the speedometer read low, because the wheel turns fewer times over a given distance than the gauge expects. The displayed speed sits below true road speed and the odometer under-records distance. A shorter tire does the opposite and pushes both readings higher. The size of the gap depends on how far the diameter moved from the stock figure. 

### Do I use the front or the rear tire for the calculation? 

Use the tire on the wheel that drives the speedometer sensor, which is the front tire on many motorcycles. On bikes that take the signal from the gearbox or the rear wheel, the rear tire and final drive ratio set the reading instead. Check where the sensor sits before you enter any size. Using the wrong wheel produces a correction that does not match the gauge. 

### Can the odometer be wrong even when the speed looks right? 

The odometer on a motorcycle can be off whenever the tire diameter differs from the stock size, even if the speed reading looks close. Speed and distance share the same signal, so both drift by the same percentage. A small error is hard to see on the speedometer but adds up over many miles of recorded distance. Note the correction in your service record so fuel and cost figures stay consistent.
