Strut Torque Specifications
Learn what strut torque specs are, why they belong in your service record, and how to find the correct figure for your vehicle before tightening strut bolts.
Contents
- What strut torque specs cover
- Why the specification is vehicle specific
- Recording torque values in service notes
- Strut Torque Questions
- Where do I find strut torque specs for my vehicle?
- Can I reuse the strut mounting bolts?
- Do I need an alignment after tightening strut bolts?
- What happens if strut bolts are too tight or too loose?
Strut torque specifications are the tightening values, given by the vehicle maker, for the bolts that hold a strut and its mount in place. Getting them right matters for suspension safety, since a strut carries the weight of the vehicle and steers the wheel. This page explains what the figures cover, where they come from, and how to record them. It also covers what a record should capture about each tightening job.
What strut torque specs cover
Strut torque specs set a tightening value for each fastener that holds the strut assembly in place. The upper strut mounting bolts clamp the top mount to the body, while the lower bolts join the strut to the steering knuckle on many designs. A separate figure often covers the nut on the shock shaft itself. Each value depends on the thread size, the material and whether the fastener is reused.
Why the specification is vehicle specific
A strut torque specification belongs to one vehicle design and cannot be borrowed from another. Bolt diameter, thread pitch, mount design and the grade of the fastener all change the correct figure. Vehicle makers publish the values in a service manual or a repair information system for that model. Using a figure from a different model can loosen a joint or damage the mount.
Recording torque values in service notes
A service record should show the strut torque values applied and the source of each figure. Note the fastener, its size, the value and whether the bolt was renewed. A suspension torque figure checked against the maker's data also shows the work was planned, not improvised. Keeping these notes with dates gives a clear history for the next inspection.
Strut Torque Questions
Where do I find strut torque specs for my vehicle?
Strut torque specs come from the vehicle maker's service manual or an official repair information system for that model. A parts supplier or a tire shop may quote a figure, but the maker's data is the source to confirm it. Match the year, model and engine before trusting any value.
Can I reuse the strut mounting bolts?
Strut mounting bolts may be reusable or single use, and the maker's procedure states which. Some suspension bolts are torque to yield, meaning they stretch and must be replaced once loosened. Check the service data before refitting a bolt that may be stretched.
Do I need an alignment after tightening strut bolts?
An alignment is needed after strut work on many vehicles, because removing the strut changes the camber or toe setting. A strut with slotted mounting holes or an eccentric bolt changes geometry when it is refitted. Follow the maker's procedure and have a trained technician check the alignment.
What happens if strut bolts are too tight or too loose?
A strut bolt that is too loose can let the joint move and damage the mount or the bolt hole. An over-tightened bolt can strip the thread or crush a rubber mount, which spoils the ride and steering. Tighten to the stated figure with a calibrated torque wrench and no more.