# Tire Pressure Light On After New Tires

Why the tire pressure light stays on after new tires, what a TPMS relearn involves, and how to record the sensor reset with your service notes.

A tire pressure light on after new tires is normal when the sensors were not relearned or the inflation pressure is set wrong for the vehicle. The warning can also come from a sensor damaged or left out during tire installation. This page explains what to check, how a TPMS relearn after new tyres works, and what to write into your service record. 

## Why the warning stays on 

A tire pressure monitoring system (TPMS) compares each wheel reading against the inflation pressure the manufacturer sets for the vehicle. New tires can hold a different amount of air than the old set, so the light may trigger until each tire is filled to the door label figure. A sensor that was broken, swapped or left out during installation also leaves the system without a reading. The light is a signal to check pressure and sensor status, not proof of a tire defect. 

## The relearn step installers owe you 

Many vehicles must be told where each new sensor sits, which is the TPMS relearn step in a tyre pressure reset procedure. Installers trigger each sensor in a set order with a scan tool or a magnet, and the vehicle then stores the wheel positions. Some vehicles relearn while you drive, so the light clears itself after a short time on the road. Ask the installer whether the sensors were reprogrammed and which method the vehicle needs. 

## Notes to keep with the receipt 

Write the service date, the odometer reading and the tire brand and size into your maintenance record. Note the inflation pressure set at each wheel and the type of TPMS sensors fitted, new or transferred. Record whether a sensor relearn was done and what tool or method was used. These details answer installer follow-up questions and keep later pressure readings comparable. 

## Questions About the Tire Pressure Light 

### Does the tire pressure light go off on its own after new tires? 

The tire pressure light can go off on its own when the vehicle relearns the sensors while driving. Many vehicles complete this learning after a short distance at a steady speed. If the light stays on after that drive, check the inflation pressure at every wheel before assuming a fault. 

### What is a TPMS relearn after new tyres? 

A TPMS relearn is the step that teaches the vehicle which sensor belongs to each wheel position. The installer triggers each sensor in a set sequence, and the vehicle stores that order for future readings. Without the relearn, a new sensor may send data the system does not link to the right tire. 

### Can I reset the light myself? 

You can reset the tire pressure light yourself on some vehicles by setting the correct inflation pressure and following the reset procedure in the owner manual. The manual names the button or menu the vehicle uses for this. A relearn that needs a scan tool or magnet is better left to a trained installer. 

### Are new tyre sensors needed with new tires? 

New tyre sensors are not needed with every set of tires, because the old sensors can often be transferred when they still work. A sensor that was damaged during removal or has reached the end of its battery life does need replacement. Ask the installer to test each sensor and note the result on your record.
